THE
FLORIDA KNIFEMAKERS' ASSOCIATION
MEMBER PROFILE
Jim Elliott
Hello, this is Jim Elliott and I thank you for taking the time to look at this web page. I have been a member of the Florida Knifemakers' Association since it's start in 1977 and a member of the Knifemakers Guild since 1998. I make knives one at a time using ATS-34, 440-C, D2 and various Damascus steels. When it comes to handle materials natural stuff like fossil ivories, bone, horn, exotic woods and pearl work best for me. I make liner lock folders, some automatics, hunters, skinners, and fillet knives. I also make the sheaths that go with them. Check the pictures below and give me a call or write concerning your particular interest. Custom orders are accepted.
FOLDER......The
blade is 2.250" of 440-C stainless steel and the knife is 3.5 inches closed.
The knife is all file worked. The handle is Fossil Walrus tusk. The thumb
stud has an opal set in it and the locking
liner is colored Titanium.
Slim
Hunter....The ATS-34 stainless steel blade is 4" with the
knife being 8" overall. The blade has file work, a tapered tang,
lanyard hole and mosaic pins in the Stag handle.
Fighter/Bowie
The blade on this Fighter is rose stainless steel
Damascus with a length of 5.750". The fittings are brass with an
Elephant ivory handle. The knife is all file worked and is 10"
overall.
How to contact me.
Jim Elliott
18175 Highway 98 North
Okeechobee, Florida, 34972
(863) 763-3265